Product range - if required - monitored and certified acc. above standards.Contents such as technical specifications, values, and dimensions are given to the best of our knowledge, however, without any guarantee and liability. If not specified otherwise, dimensions are given in millimetres. Our General Terms and Conditions shall apply.
After production, place the inner and outer support ring on the spigot and release from the formwork together with the pallet ring only after the concrete is hardened. After the concrete has fully hardened, the pipe is ready for assembly.Fabrication of pipes:The necessary lubricant Cordes GM-95 is applied liberally by hand to the spigot of the concrete element, starting at the radius. Observe EN 1610 when laying the pipe.Material:Anchor-2000 seals are fabricated from styrene butadiene rubber (SBR). The use of SBR has proven its worth in rainwater and wastewater applications due to its excellent sealing characteristics. Note: We recommend using seals made of nitrile butadiene rubber (NBR) for applications involving mineral fuels such as oils, petrol or similar.
Anchor-2000The integrated Anchor-2000 socket seal for concrete and reinforced concrete pipes as per EN 1916 and DIN V 1201 as well as FBS quality guideline for normal and deep sockets. Benefits:•The Anchor-2000 seal is fixed in the socket, completely lines it and forms a single constructional unit with the concrete pipe.•This prevents seals from being faulty or left out completely.•The Anchor-2000 seal provides for additional safety due to its massive geometry.•The Anchor-2000 seal is resistant against shear loads, root-proof and can withstand both internal and external pressure, as well as pressures from pipe cleaning.The Anchor-2000 seals are subject to constant inspection by authorized third-party institutions. They comply with the requirements of EN 1916, EN 681-1, QR 4060 (FBS quality guideline) as well as other applicable quality standards.Fabrication of pipes:Mount the Anchor-2000 seal on the profiled pallet ring and make sure that the seal fits properly. The pallet ring must be free of dirt in the area of the seal. Prior to the compression, fill the pipe form with concrete to above the area of the socket. Then produce the concrete pipe as usual.